Posts by EMS

Introduction to Copper in PCB Design Copper is the primary conductive material used in printed circuit board (PCB) design due to its excellent electrical conductivity,[…]

What is PCB Warpage? PCB warpage, also known as bow and twist, is a common issue encountered during the manufacturing process of printed circuit boards[…]

Introduction to Embedded World 2024 Embedded World is the world’s leading trade fair for embedded systems technology. It is an annual event that takes place[…]

Introduction to Placer-camera machines Placer camera-assisted manual pick and place machines have revolutionized the manufacturing industry by providing a cost-effective and efficient solution for assembly[…]

What is Soldermask Made of? Soldermask is typically composed of a photoimageable polymer that is applied to the surface of a PCB. The most common[…]

Introduction to Rayming-reflow-pilot Rayming-reflow-pilot is a cutting-edge technology designed to optimize the reflow soldering process in electronics manufacturing. This innovative system ensures precise control over[…]

Introduction Printed circuit board (PCB) design is a complex process that requires careful attention to detail and adherence to best practices to ensure optimal performance,[…]

What is Selective Soldering? Selective soldering is an automated process that uses a targeted approach to solder specific through-hole components onto a PCB, while leaving[…]

Introduction to IPC-A-600 Standards The IPC-A-600 standard, developed by the Association Connecting Electronics Industries (IPC), is a widely recognized and accepted set of guidelines for[…]

Table of Contents Introduction to PCB via holes Types of PCB Via Holes Through Hole Vias Blind Vias Buried Vias Microvia Functions of PCB Via[…]